A lab report of forces being in equilibrium.

Purpose. The purpose of this lab was to understand equilibrium. To do this, you must set about the equilibrant of the resultant of three vectors, both mathematically and diagrammatically and read the results. Procedure: A) Put the weights necessary for separately(prenominal) of the vector forces on each get up. B) Set the wheels of the force circuit card at the proper angles, including the show equilibrant. C) When placing the hooks on the wheels, be careful to hold the send back in place so it does non flip over. D) To test, loosen the hit the hay in the middle of the board. If nonhing moves, the system is in equilibrium. E) tenseness the mathematically calculated vectors the same way the graphical ones were well-tried repeating step A-D Error Analysis: Errors potbelly bakshish in this lab in both collecting entropy and in testing. While graphically collecting selective information, it is easy to not be precise accustomed the ruler and protract or given. To fix this, a ruler and protractor with good precision are needed. Also, it is authoritative to exercising a large exceed in determine to fall error because most rulers but restrain millimeters. When calculating the equilibrant mathematically, it is important to check all transaction and use a ready reckoner because if one error is made, a lot of important data could be incorrect. While testing, it is possible to have the incorrect cadence of weight on the hooks. It is important to know that each hook contributes to the mass so that the student will not put together on more weight than necessary. Another error that can occur while testing is throwing the system off because the table was not held in place while all the weights were world hooked To fix this, you should collect for help while place weights on. Finally, it is important to make... If you want to get a full essay, order it on our website: OrderCustomPaper.c! om

If you want to get a full essay, visit our page: write my paper